Changing The Ph Buffer Group - Oakton pH 5+ Instruction Manual

Instruction Manual

Changing the pH Buffer Group

1. Power off the meter while in pH mode. Press and hold

successful, "
2. Press to enter the buffer group selection mode.
3. Press to toggle between the available pH buffer groups:
to confirm the pH buffer group. Note: If  is selected, measurement
4. Press
mode will begin. If  or  is selected, proceed to step 5.
5. Press to toggle between the desired number of calibration points (Pt). Note:
During pH calibration mode, the meter will automatically complete calibration after
the number of points selected here has been completed.
6. Press to confirm the number of calibration points. The meter will automatically
begin to measurement mode.
To abort the buffer group selection or go back one step, press
" will blink on the display. Release both keys.
8
pH 5+, pH 6+, Ion 6+
then press . If
.