Lexmark X790 Series User Manual page 150

Understanding the printer menus
Menu item
Job Buffering
Off
On
Auto
Mac Binary PS
Auto
On
Off
ENA Address
yyy.yyy.yyy.yyy
ENA Netmask
yyy.yyy.yyy.yyy
ENA Gateway
yyy.yyy.yyy.yyy
Parallel [x] menu
Menu item
PCL SmartSwitch
On
Off
PS SmartSwitch
On
Off
Description
Temporarily stores print jobs on the printer hard disk before printing
Notes:
•
Off is the factory default setting.
•
On buffers jobs on the printer hard disk.
•
Auto buffers print jobs only if the printer is busy processing data from another
input port.
•
Changing this setting from the printer control panel and then exiting the
menus causes the printer to restart. The menu selection is then updated.
Sets the printer to process Macintosh binary PostScript print jobs
Notes:
•
Auto is the factory default setting.
• On processes raw binary PostScript print jobs.
•
Off filters print jobs using the standard protocol.
Sets the network address information for an external print server
Note: This menu item is available only if the printer is attached to an external print
server through the USB port.
Sets the netmask information for an external print server
Note: This menu item is available only if the printer is attached to an external print
server through the USB port.
Sets the gateway information for an external print server
Note: This menu item is available only if the printer is attached to an external print
server through the USB port.
Description
Sets the printer to automatically switch to PCL emulation when a print job received
through a serial port requires it, regardless of the default printer language
Notes:
•
On is the factory default setting.
•
When set to Off, the printer does not examine incoming data. The printer uses
PostScript emulation if PS SmartSwitch is set to On. It uses the default printer
language specified in the Setup menu if PS SmartSwitch is set to Off.
Sets the printer to automatically switch to PS emulation when a print job received
through a serial port requires it, regardless of the default printer language
Notes:
•
On is the factory default setting.
•
When set to Off, the printer does not examine incoming data. The printer uses
PCL emulation if PCL SmartSwitch is set to On. It uses the default printer
language specified in the Setup menu if PCL SmartSwitch is set to Off.
150