HP LP 1000r Service Manual page 46

Chapter 4
Code Description
0530 Hard Disk drive
connection problem
The IDE cable
(primary channel)
marked IDE cable
<#0530>. The
secondary channel
cable marked IDE2
<#0531>
(This does not apply
to LP 1000r)
0540 Hard Disk Controller
resource conflict
(This does not apply
to LP 1000r)
0600 Video Memory boot
error
0700 DIMM size boot error
40
Problem/Solution
POST has detected a hard disk drive on the second <slave>
position on the IDE cable, but no hard disk has been found on
the first <master> position.
To correct this:
1. If only one hard disk is connected on the cable, disconnect
the hard drive and use the other connector to re-connect the
hard drive into the first <master> position.
2. If two disks are connected on the cable, verify all data cables
and power cables are firmly connected for both hard disk
drives.
3. If the error message appears just after a hard disk drive
installation, check for master/slave specific jumper
configurations in the hard disk drive installation manual.
4. If the problem persists, the hard disk drive may need to be
replaced. Contact your service representative.
POST has detected an address space or IRQ resource conflict
between the integrated hard disk controller and an accessory
board.
To correct this:
1. If the integrated hard disk controller is not needed, run the
Setup Utility to disable it (primary or secondary).
2. If the integrated hard disk controller is needed, the accessory
board's IRQ and address space must be reconfigured to use
other free resources. Refer to the accessory board
installation manual for information.
The video memory size detected during POST is smaller than
previously detected. (This would apply if the embedded video
circuitry was defective, or a video adapter board were installed
into LP 1000R to increase the video speed and memory.)
To correct this:
1. If you have changed to a video adapter board, press [F4] to
automatically validate the change.
2. If the problem persists, the system board or video board may
need to be replaced. Contact your service representative.
POST has detected system memory size is smaller than
previously detected. At least one or several DIMMs are
disconnected, or have been replaced by smaller ones.
To correct this:
1. If some DIMMs have just been removed or replaced by
smaller ones, press [F4] to automatically validate the change.
Diagnostics