HP LP 1000r Service Manual page 53

Chapter 4
WARNING
1. Power down the HP Netserver and unplug power cord.
2. Remove the Netserver cover and the cooling duct/cover.
3. If the chassis is out of the rack, lay it on a flat surface with the system board components facing
up.
4. If necessary remove the PCI board, which may prevent access to the battery.
5. Insert a small flatblade screwdriver or similar tool between the battery and spring latch.
6. Push the spring latch away from battery to release the battery.
The spring contacts beneath the battery cause it to pop up allowing you to grasp the battery.
7. Remove the existing battery.
8. Insert the new battery with the positive sign (+) facing up in the socket.
9. Press down on the center of the battery with your thumb, pushing the battery down into the
socket.
The battery should snap into place.
10. Ensure the spring latch holds the battery firmly.
11. Replace the cooling duct/cover and the Netserver cover.
12. Power on the Netserver and reset the CMOS settings.
There is a danger of explosion if the battery is incorrectly installed. For your safety,
never attempt to recharge, disassemble, or burn the old battery. Replace only with
the same or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer's instructions.
Battery on System Board
Diagnostics
47