Power-On Self Test (Post) Error Codes - HP LP 1000r Service Manual

Chapter 4
Message Corrective Action
•
If no message
appears
(screen is
•
blank)
If a If a Netserver configuration error is reported during the startup routine, clear the
configuration CMOS memory as described under "Clearing the CMOS Configuration," and restart
error occurs the Netserver.
•
System CMOS
checksum bad
•
•

Power-On Self Test (POST) Error Codes

These error codes (POST codes) appear in normal video if an error condition occurs during the boot process
of the HP Netserver LP 1000r. All the codes and the respective descriptions are listed in the HP Netserver
LP 1000r Service Manual, but not all the codes apply to this Netserver. The service manual is also located
on the HP Netserver Online Documentation CD-ROM provided with the HP Netserver.
These codes will appear on the display monitor, provided it and the supporting circuitry are functioning:
NOTE
32
If no text or messages appear listen for the beep codes. Refer to Beep Codes
in Table 4-3.
If no message appears but the Netserver stops after POST, verify the DIMMs
are correctly installed.
Press [F2] to run Setup.
Change settings as required.
Choose the Exit option, selecting Save Changes and Exit to save the new
settings.
The Netserver should reboot.
Do not take remove/replacement actions until you have taken other troubleshooting
steps. See the troubleshooting checklist.
Diagnostics