Monitor Mode - Toshiba Q9 Plus ASD Quick Start Manual

Monitor Mode

The Monitor mode allows the user to monitor motor performance variables, control settings, and
configuration data during motor operation. The items are listed and described below.
Press the Rotary Encoder to access the listing of monitored parameters. Turn the Rotary Encoder to
access subsequent monitored parameters.
Note: The Monitor mode is a read-only mode. The settings cannot be changed from the
Monitor mode. For information on how to change the values, see the section titled
Default Setting Changes on pg.
Note: Any two of the Underlined monitored items may be selected for display at the
Frequency Command screen while running via Program
Selections.
Note: The F701 setting will determine if the Current and Voltage values displayed appear as
A (Amps) or V (Voltage), or if the value is shown as a % (Percentage) of the ASD
rating.
Frequency at Trip — Displays the at-trip frequency.
Frequency Reference — Displays the Frequency Setpoint (commanded frequency).
Output Current — Displays the Output Current as a percentage of the rated capacity of the ASD.
DC Voltage — Displays the DC Bus Voltage as a percentage of the rated capacity of the ASD.
Output Voltage — Displays the Output Voltage as a percentage of the rated capacity of the ASD.
AM Output — Displays the magnitude of the function assigned to this terminal relative to the full-
scale reading of the AM terminal. This terminal may be configured at F670 for application-specific
suitability.
FM Output — Displays the magnitude of the function assigned to this terminal relative to the full-
scale reading of the FM terminal. This terminal may be configured at F005 for application-specific
suitability.
Motor OL (Overload) Real — Displays the real-time Motor Overload value as a percentage of
the rated capacity of the motor.
Motor OL (Overload) Trip — Displays the Motor Overload Trip value as a percentage of the
rated capacity of the motor.
Motor Load — Displays the real-time Motor Load as a percentage of the rated capacity of the
motor.
ASD OL (Overload) Real — Displays the real-time ASD Overload as a percentage of the rated
capacity of the ASD.
ASD OL (Overload) Trip — Displays the ASD Overload Trip value as a percentage of the rated
capacity of the ASD.
ASD Load — Displays the ASD Load as a percentage of the rated capacity of the ASD.
Run Time — Displays the Cumulative Run Time in hours. Select Clear Run Timer at F007 to
reset this reading.
Compensation Frequency — Displays the Output Frequency after the application of the slip
compensation correction value (post compensation frequency).
DBR OL (Overload) Real (not used) — Displays the real-time DBR Overload value as a
percentage of the Dynamic Braking Resistor capacity.
Q9 Plus ASD Quick Start Guide
57.
 
Utilities Main Monitor
31