Eoi Command Mode - Toshiba Q9 Plus ASD Quick Start Manual

EOI Command Mode

The EOI Command mode is accessed by pressing the ESC key from the Frequency Command screen.
With the exception of the Virtual Linear Pump Control Enable/Disable, the control settings of the EOI
Command menu are effective for EOI control only.
The EOI Command mode provides quick access to the following menu parameters:
Direction — Forward or Reverse.
Stop Pattern — The Decel Stop or Coast Stop setting determines the method used to stop the
motor when using the Stop-Reset key of the EOI. The Decel Stop setting enables the DC Injection
Braking system setup at F250, F251, and F252. The Coast Stop setting allows the motor to stop at
the rate allowed by the inertia of the load.
Note: The Stop Pattern setting has no effect on the Emergency Off settings of F603.
V/f Group — One of four V/f profiles may be selected and run. Each V/f profile is comprised of four
user settings: Base Frequency, Base Frequency Voltage, Manual Torque Boost, and Electronic
Thermal Protection. Expanded descriptions of these parameters may be found in the section titled
Direct Access Parameter Information in the Q9 Plus Installation & Operation Manual.
Accel/Decel Group — One of two Accel/Decel profiles may be selected and run. Each of the
Accel/Decel profiles is comprised of three user settings: Acceleration, Deceleration, and Pattern.
Expanded descriptions of these parameters may be found in the section titled Direct Access
Parameter Information in the Q9 Plus Installation & Operation Manual (see F009).
PID Control — This setting enables or disables the PID feedback function.
Torque Limit Group — This group is used to select preset positive torque limits to apply to the
active motor (of a multiple motor configuration). The settings may be accessed at F440, F441, F442,
and F443, respectively.
VLP Technology Control — This setting enables or disables the Virtual Linear Pump function.
30 Q9 Plus ASD Quick Start Guide