Toshiba Q9 Plus ASD Quick Start Manual page 77

Binary Value
Object Name
Object ID
Binary Value #14
Fault Reset
(BV14)
Binary Value #18
Preset Spd 1
(BV18)
Binary Value #19
Preset Spd 2
(BV19)
Binary Value #20
Preset Spd 3
(BV20)
Binary Value #21
Freq Ovrd
(BV21)
Binary Value #22
Cmd Ovrd
(BV22)
R = Read-only; C = Commandable
Analog Input Analog Input
Terminal Object ID
Analog Input #0
RR
(AI0)
Analog Input #1
V/I
(AI1)
Analog Input #2
RX
(AI2)
Analog Input #3
AI1*
(AI3)
Analog Input #4
AI2*
(AI4)
* The ETB004Z expansion I/O card is required to use this input.
R = Read-only
Q9 Plus ASD Quick Start Guide
®
Table 5. BACnet Binary Values. (Continued)
Description
Commands the drive to reset a fault
Commands the Preset Speed 1 operation
Commands the Preset Speed 2 operation
Commands the Preset Speed 3 operation
Overrides the Frequency Mode 1 (F004) selection
Overrides the Command Mode (F003) selection
®
Table 6. BACnet
Object Name
RR Level Input level of the RR analog input
V/I Level Input level of the V/I analog input
RX Level Input level of the RX analog input
AI1 Level Input level of the AI1 analog input
AI2 Level Input level of the AI2 analog input
Analog Inputs.
Description
Status Access
Reset/No C
SP1/None C
SP2/None C
SP3/None C
Enabled/Off C
Enabled/Off C
Value Access
Percent (%)
R
of full scale
Percent (%)
R
of full scale
Percent (%)
R
of full scale
Percent (%)
R
of full scale
Percent (%)
R
of full scale
69