Eoi Features - Toshiba Q9 Plus ASD Quick Start Manual

LED/LCD Screen Installation Note
When installing the LED/LCD display unit of the EOI, ensure that the left side of the display is inserted
first with the top and bottom catches (see Phillips screws at underside of display) securely in place. This
ensures the proper alignment and electrical connection of the CNX connector of the LED/LCD display
unit board. Gently hold the display in place while securing the Phillips mounting screw.
If improperly seated, the periphery of the LED/LCD display unit will not be flush with the EOI surface,
and the unit will not function properly.
Figure 21. The Q9 Plus ASD Electronic Operator Interface Features.
LED/LCD Display Unit
Remove the Phillips screw
first to remove the LED/
LCD display unit to activate
the Battery Backup system.
LED Screen
LCD Screen

EOI Features

LED Screen
LCD Screen
voltage, torque, etc.), diagnostic information, and LED screen information in expanded normal text.
Rotary Encoder
parameter, and perform the Enter key function. Turn the Rotary Encoder either clockwise or
counterclockwise to perform the Up or Down functions of the displayed menu selection. Press the Rotary
Encoder to perform the Enter (select) function.
Hand/Auto Key
the system is in the Hand Command mode. The Hand mode allows the Command and Frequency
control functions to be carried out via the EOI.
The Auto mode enables the Command and Frequency control functions to be carried out via the
Terminal Board, RS485, Communication Card, or Pulse Input. The selection may be made via
Program  Fundamental  Standard Mode Selection 
respectively.
Note: See the Q9 Plus Installation & Operation Manual for more information on system
control.
ESC Key
— Returns the system to the previous level of the menu tree, toggles between the EOI
ESC Key
— Returns the system to the previous level of the menu tree, toggles between the EOI
Command screen and the Frequency Command screen, or cancels changes made to a field if pressed
while still in the reverse video mode (dark background/light text). The three functions are menu-specific.
Run Key
— Issues the Run command while in the Hand mode. The Run key LED illuminates green
while stopped and red while running or exciting the motor.
26
— Displays the running frequency, active Fault, or active Alarm information.
— Displays configuration information, performance data (e.g., output frequency, bus
— Used to access the Q9 Plus ASD menu selections, change the value of a displayed
— Toggles the system to and from the Hand and Auto modes. The LED is on when
Rotary Encoder
Hand/Auto Key (LED)
Escape Key
Run Key (LED)
Mode Key
Stop/Reset Key
Command Mode and Frequency Mode
Q9 Plus ASD Quick Start Guide
1,