System Configuration And Menu Options; Root Menu Items; Frequency Command Mode - Toshiba Q9 Plus ASD Quick Start Manual

System Configuration and Menu Options

Root Menu Items

The Mode key accesses the three primary modes of the Q9 Plus ASD: the Frequency Command mode,
the Monitor mode, and the Program mode. From either mode, press the Mode key to loop through to the
other two modes (see Figure 25). Press the ESC key from any mode to return to the previous mode until
reaching the Frequency Command mode.
The Alarm or Fault information will be displayed in the event of an active Alarm or Fault. Alarm text
will be displayed on the Frequency Command screen when active. Fault information will be displayed
via a Fault screen. See Alarms, Trips, and Troubleshooting on pg. 72 for more information.
Figure 25. Q9 Plus ASD Root Menu Navigation.

Frequency Command Mode

Frequency Setting
While operating in the Hand mode (Hand LED is illuminated), the running frequency of the motor may
be set from the Frequency Command screen. Using the Rotary Encoder, enter the Frequency
Command value, connect ST to CC, provide a Run command (F and/or R) and then press the Run key.
The motor will run at the Frequency Command speed and may be changed while running. See Operation
(Hand) on pg. 56 for more information on the Frequency Command mode.
Q9 Plus ASD Quick Start Guide 29