Source Keyboard/Mouse (Usb-Type B) Device Ports 1-4; Usb (Type A) Input Ports; Ethernet 10/100 (Rj-45) Port - AMX TPI-PRO-DVI-2 Instruction Manual

SOURCE KEYBOARD/MOUSE (USB-Type B) Device Ports 1-4

The USB (Type B) Device ports on the rear panel (labeled "SOURCE KEYBOARD/MOUSE") are used to connect up to four source PCs
to the TPI to provide pass-through control for the connected PCs (FIG. 12).
SOURCE KEYBOARD/MOUSE (USB-Type B) Device Ports
FIG. 12
NOTE: The TPI requires that the host PC uses USB v2.0.
The TPI-PRO-DVI-2 has two USB-Type B Device Ports (corresponding with DVI Inputs 1-2)

The TPI-PRO-DVI-4 has four USB-Type B Device Ports (corresponding with DVI Inputs 1-4)

These numbered USB Device ports correspond to the numbered DVI Inputs:
1. The PC connected to USB Device port #1 has pass-through control of the input device connected to DVI Input #1.
2. The PC connected to USB Device port #2 has pass-through control of the input device connected to DVI Input #2.
3. The PC connected to USB Device port #3 has pass-through control of the input device connected to DVI Input #3 (TPI-PRO-
DVI-4 only).
4. The PC connected to USB Device port #4 has pass-through control of the input device connected to DVI Input #4 (TPI-PRO-
DVI-4 only).

USB (Type A) Input ports

The two USB (Type A) Input ports on the rear panel are used to connect USB touch/input devices to the TPI (FIG. 13).
Rear Panel USB (Type A) Input Ports
FIG. 13
NOTE: Touch/input devices can consist of any combination of a keyboard, mouse, or USB-capable touch screen.
Note that there are two additional USB (Type A) Input ports on the front panel (see FIG. 8 on page 25). All of the USB Input ports
have the same functionality; they are provided on both sides of the TPI for ease-of-access.

ETHERNET 10/100 (RJ-45) Port

The ETHERNET 10/100 (RJ-45) port provides 10/100 Mbps communication with the NetLinx Master via ICSP protocol (FIG. 14).
ETHERNET 10/100 (RJ-45) Port
FIG. 14
The Ethernet port automatically negotiates the connection speed (10 Mbps or 100 Mbps), and whether to use half duplex

or full duplex mode.
FIG. 15 describes the blink activity for the ETHERNET 10/100 Base-T RJ-45 connector LEDs.

A - Activity LED (yellow)
lights when receiving or
transmitting Ethernet
ETHERNET connector / LEDs
FIG. 15
TPI-PRO-DVI - Instruction Manual
A
data packets
USB (Type B) Device Port 1
USB (Type B) Device Port 2
USB (Type B) Device Port 3
USB (Type B) Device Port 4
2 USB (Type-A) Input ports
ETHERNET 10/100 (RJ-45) port
L
L - Link LED (green) lights when
the Ethernet cables are connected
and terminated correctly.
Wiring and Device Connections
28