Vision Fitness X6000 Assembly Manual page 6

PINK BAG
3
STEP
• X6000 only: Unfold the RPM sensor
wire, located in the frame console
mast bracket. Remove any kinks.
• All models: Slide the rubber console
mast cover onto the bottom of console
mast, and slide it up as far as it will
go.
• All models: Unfold the console
cable and attach it to the string
located at the bottom of the console
mast. Guide the wire up through the
mast, while simultaneously sliding the
console mast onto the frame bracket.
X6000 NOTE: You will also slide the
tension cable up through the mast at
this point.
• All models: Bolt the console mast
to the frame bracket with two bolts
(M8 x 60
(M8), and two lock washers (M8).
Tighten with the Blue 5
wrench. Slide the rubber console mast
cover back down over the bolt heads.
X6000 NOTE: Be sure the RPM
sensor wire exits through the small slot
at the top right side of the the console
mast.
• X6000 only: Install the batteries into
the console. Mount console to console
mast, using the four screws. Plug the
RPM sensor wire into the back of the
console, and feed the excess back
down into the small slot in the console
mast.
• X6000 only: Turn the tension knob
to Level 15. Reach inside the console
mast and connect the magnet cables.
Turn the knob to Level 1 and mount the
knob using a bolt (M5 x 25
• X6200HRT only: Remove the four
screws from the back of the console.
Plug the wire connector from inside
the mast into the console. The cable
connector is slotted, so it may only be
connected one way; do not force it!
CONTINUE...
), two flat washers
MM
Allen
MM
).
MM
3
STEP
X6000
OR
X6200HRT
X6000
Only
CONTINUED
X6200HRT only:
•
console to the mast using the four
screws. Do not pinch the cable!
• All models: Bolt the water bottle
cage to the console mast using the
two bolts located in the mast.
6
Mount the