Vision Fitness X6000 Assembly Manual page 5

ORANGE BAG
1
STEP
• Insert the rear folding axle shaft into
the rear tube.
• Slide a spring washer (M16) onto
the right-hand side of the rear folding
axle, followed by the right-hand pedal
arm guide rail (the guide rails each
have a blue indicator arrow printed
on their sides; these arrows should
face to the outside).
• Slide a flat washer (M16) onto the
right-hand side of the rear axle,
followed by a rear wheel.
• Slide the large flat washer
(M8) onto the right-hand side of the
rear axle, and secure with a bolt (M8
x 16 ).
MM
• Repeat above steps to install left-
hand pedal arm guide rail.
• X6200HRT only: Screw the locking
knob into the top toe piece. Place the
top and bottom toe pieces onto the
pedal arm and attach with two
washers (M5)
(M5 x 25 ).
MM
BLUE BAG
2
STEP
• Slide the front foot axle into the
plastic sleeve of the front foot. Place a
wavy washer (16 x 29 x 1.5) on
each end of the axle.
• Place a transport wheel on each
end of the axle.With the blue-
handled 5
MM
bolts (M8x20L)
(8x30x1.5) to each end of the axle to
secure the transport wheel.
and two bolts
Allen wrench, tighten
and washers
X6200HRT
Only
X6000
Only
5
1
STEP
2
STEP