Related Manuals for Hydromatic JB-1
Summary of Contents for Hydromatic JB-1
- Page 1 Pump Installation and Service Manual JB-1 System Sewage Ejector Pump Package NOTE! To the installer: Please make sure you provide this manual to the owner of the pumping equipment or to the responsible party who maintains the system.
-
Page 2: General Information
Hidden damage can should be performed by an this product. Read this manual occur during shipment. If the authorized Hydromatic service completely before using this unit is found to be damaged station only. product and refer to it often for... - Page 3 5. Set pump in pump housing only as recommendations when Pump System with discharge toward the right installing the JB-1 alone or as part back corner as viewed from Installation of a complete bathroom. toilet opening. The vertical...
- Page 4 11.The discharge pipe should 17.Lubricate 2" rubber pipe seal WARNING: The tank and lid protrude approximately 4" with soapy water and push it will expand with the water above the surface of the lid. into 3" drilled hole. Lubricate column pressure while tested. Attach the check valve (Fig.
- Page 5 Pump END VIEW Warning Figure 1 SIDE VIEW Figure 2...
-
Page 6: Pump Troubleshooting
Hydromatic plugged. Remove pump and service center. clean out. Hydromatic pumps have a small Servicing should be performed air vent hole in the impeller cavity 3. Pump impeller only by an authorized Hydromatic to let out trapped air. If this hole... -
Page 7: Parts List
JB-1 System Parts List Figure 3— Installation Hardware Kit Item Description Qty. 1/4"–20 x 5/8" Hex Head Bolts 20 Flat Washers–.320 I.D. 5/16" x 2" Stud and Nuts Check Valve Wax Ring (Retail Boxed) 1/2" Foam Gasket Material 2" Adapt-A-Flex Pipe Grommet... - Page 8 All dual seal non-clogs and 3–5 HP grinders must have seal failure and heat sensors attached and functional for Warranty to be in effect. If a seal failure should occur, Hydromatic will cover only the lower seal and labor thereof. Labor is based on Authorized Service Center contract allowance. If the heat sensor is not attached and functional, Warranty is void.
Need help?
Do you have a question about the JB-1 and is the answer not in the manual?
Questions and answers