Page 1
Installation and Service Manual SUBMERSIBLE PUMP WITH HAZARDOUS LOCATION MOTOR END Model S4HVX (Class I, Division 1, Groups C & D): FM (Hazardous Location Motor End) NOTE! To the installer: Please make sure you provide this manual to the owner of the equip ment or to the responsible party who maintains the system.
Once fol low ing manual carefully. should be done by a Hydromatic sensor re sets, the starter is approved ser vice center. automatically reset for FM for continued operation of the pump.
For installation of Hydromatic protected as recommended, drops to turn-off point. sup plied level con trols refer to Hydromatic war ran ty is void. your sys tems installation and 9. Repeat this operation cycle See Page 5. service manual.
(on sump a test light is provided on normal service. mounted con trol panels) and cord in trin si cal ly safe Hydromatic as sem bly taken with pump. panels as standard equipment. Replacing Stator: Pump should be checked every...
Page 5
TYPICAL FM ONLY SCHEMATICS TYPICAL SINGLE PHASE MOTOR CONNECTIONS PUMP MOTOR WHITE HEAT SENSORS 120 VAC, 5A BLACK SEAL PROBES 300 VAC, 20 MA FUSES CAPACITOR GREEN 330K 120 VAC START CAPACITOR POWER SEE TYPICAL CONTROL CIRCUITRY CORD CAPACITOR BELOW CONTROL PACK PANEL CORD...
Page 6
1" below plug hole. Use only up through rotor core. 6. Set seal housing in upright Hydromatic sub mers ible oil or po si tion and bump end of shaft high grade trans form er oil in on hard wood block. This will IMPORTANT: Use only butt this chamber.
Page 7
11.Use Locktite (red) on socket Hydromatic factory. head locking screw in end of shaft. 8. IMPORTANT: Do not use any of the old seal parts. 12.Before refilling chamber with Replace with all new seals. oil, air test as described in replacing stator.
S4HVX Parts List For use with product built with USEM motor. ORDERING REPLACEMENT PARTS: Product improvements are made from time to time. The latest part design will be fur nished as long as it is in ter change able with the old part.When ordering re place ment parts, always furnish the fol low ing information: (1) pump serial num ber, (2) pump model and size, (3) part description, (4) part number, (5) im pel ler diameter (if ordering impeller), (6) quan ti ty required, and (7) shipping instructions.
Wiring Diagrams PROBE TEST RESISTOR PROBE TEST RESISTOR ON HAZARDOUS LOCATION ONLY ON HAZARDOUS LOCATION ONLY – – PROBE TEST RESISTOR PROBE TEST RESISTOR ON HAZARDOUS LOCATION ONLY ON HAZARDOUS LOCATION ONLY – –...
12 months ® from the date of shipment from Hydromatic or 18 months from the manufacturing date, whichever occurs first - provided that such products are used compliance with the requirements of the Hydromatic catalog and technical manuals for use in pumping raw sewage, municipal wastewater or similar, abrasive free non-corrosive liquids.
Acknowledge that all information is accurate and proper procedures have been followed. Customer: ___________________________________________________________________ Date: _____________ Start-up Technician:___________________________________________________________ Date: _____________ Send to Warranty Manager, 1101 Myers Parkway, Ashland, OH 44805 or Fax to 419-207-3344 or email to startupreport@hydromatic.com or submit online at http://forms.pentairliterature.com/startupform/startupform.asp?type=h...
Need help?
Do you have a question about the S4HVX Series and is the answer not in the manual?
Questions and answers