Table of Contents
Advertisement
Installation and Service Manual
H Z RDOUS LOC TION
SUBMERSIBLE PUMP
Model S4NX
NOTE! To the installer: Please make sure
you provide this manual to the owner of
the equipment or to the responsible party
who maintains the system.
For use with product
built with Regal Beloit/
Marathon motor.
( lass I, Division 1, Groups
& D): FM
© 2010 Pentair Pump Group, Inc.
10/10
Item # E-03-332
Part # 5625-332-1
Advertisement
Table of Contents
Related Manuals for Hydromatic S4NX
Summary of Contents for Hydromatic S4NX
- Page 1 Installation and Service Manual H Z RDOUS LOC TION SUBMERSIBLE PUMP Model S4NX ( lass I, Division 1, Groups & D): FM NOTE! To the installer: Please make sure you provide this manual to the owner of the equipment or to the responsible party who maintains the system.
-
Page 2: General Information
This prevents following manual carefully. should be done by a Hydromatic damage motor. approved service center. sensor trips due to excessive Before operation: winding temperature, starter in... -
Page 3: Installation Instructions
Connections: Before installing pump in sump, higher than a corresponding lay it on side and rotate impeller. If a Hydromatic control panel horsepower surface motor, so Impeller may be slightly stuck is used, terminal blocks are heaters must be sized by the... -
Page 4: Pump Maintenance
Field Service on Hydromatic assembly and install protective drops to turn-off point. Hazardous Location Pumps: cover. (Hydromatic Kit 11159- 9. Repeat this operation cycle... -
Page 5: Level Control
TYPICAL FM ONLY SCHEMATICS TYPICAL SINGLE PHASE MOTOR CONNECTIONS PUMP MOTOR WHITE HEAT SENSORS 120 VAC, 5A BLACK SEAL PROBES 300 VAC, 20 MA FUSES CAPACITOR GREEN 330K 120 VAC START CAPACITOR POWER SEE TYPICAL CONTROL CIRCUITRY CORD CAPACITOR BELOW CONTROL PACK PANEL CORD... - Page 6 TYPICAL UL ONLY SCHEMATICS TYPICAL SINGLE PHASE MOTOR CONNECTIONS PUMP MOTOR WHITE HEAT SENSORS 120 VAC, 5A BLACK SEAL PROBES 300 VAC, 20 MA FUSES CAPACITOR GREEN 330K 120 VAC START CAPACITOR POWER SEE TYPICAL CONTROL CIRCUITRY CORD CAPACITOR BELOW CONTROL PACK PANEL CORD...
-
Page 7: Maintenance
7. After ring is removed, turn If bearings are damaged with Pump housing upright and bump on dirt or heat, they must be Maintenance hardwood block. This should replaced. additional jar the stator loose and allow it instructions on replacing seals to drop out. - Page 8 1" below plug hole. Use only 7. Use bearing puller to remove Hydromatic submersible oil or 14.Always check all leads with bearings. Replace with new high grade transformer oil in high voltage or with Megger bearings.
-
Page 9: Wiring Diagrams
Wiring Diagrams PROBE TEST RESISTOR PROBE TEST RESISTOR ON HAZARDOUS LOCATION ONLY ON HAZARDOUS LOCATION ONLY – – PROBE TEST RESISTOR PROBE TEST RESISTOR ON HAZARDOUS LOCATION ONLY ON HAZARDOUS LOCATION ONLY – –... -
Page 10: Parts List
S4NX Parts List For use with product built with Regal Beloit/Marathon motor. ORDERING REPLACEMENT PARTS: Product improvements are made from time to time. The latest part design will be furnished as long as it is interchangeable with the old part.When ordering replacement parts, always furnish the following information: (1) pump serial number, (2) pump model and size, (3) part description, (4) part number, (5) impeller diameter (if ordering impeller), (6) quantity required, and (7) shipping instructions. - Page 11 S4NX 47 39 45 41 40 46 20 21 22 23 Figure 1 CONNECTION DIAGRAM FOR LEADS IN MOTOR AND CONNECTION BOX 230 VOLTS 460 VOLTS GREEN GREEN...
- Page 12 Pump Notes...
- Page 13 Pump Notes...
-
Page 14: Standard Limited Warranty
12 months from the date of shipment from Hydromatic or 18 months from the manufacturing date, whichever occurs first - provided that such products are used compliance with the requirements of the Hydromatic catalog and technical manuals for use in pumping raw sewage, municipal wastewater or similar, abrasive free non-corrosive liquids. -
Page 16: Start-Up Report
Acknowledge that all information is accurate and proper procedures have been followed. Customer: ___________________________________________________________________ Date: _____________ Start-up Technician:___________________________________________________________ Date: _____________ Send to Warranty Manager, 1101 Myers Parkway, Ashland, OH 44805 or Fax to 419-207-3344 or email to startupreport@hydromatic.com or submit online at http://forms.pentairliterature.com/startupform/startupform.asp?type=h...
Need help?
Do you have a question about the S4NX and is the answer not in the manual?
Questions and answers