Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Hydromatic HPGR200
Summary of Contents for Hydromatic HPGR200
- Page 1 Pump Installation and Service Manual HPGR200 Submersible Grinder Pump NOTE! To the installer: Please make sure you provide this manual to the owner of the pumping equipment or to the responsible party who maintains the system.
-
Page 2: General Information
National Electrical Code and all applicable local codes Do not smoke or use sparkable Thank you for purchasing your and ordinances. This marking electrical devices or flame in a Hydromatic ® pump. To help required phase septic (gaseous) or possible ensure years of trouble-free models only. -
Page 3: Pump Operation
In either case, be discharge gate valve. Then lift sure that the Hydromatic nonclog pump until sealing flange is open Replacing Grinder Parts: check valve is used and that the to vent off trapped air. -
Page 4: Performance Curve
cutter (14) lifts off impeller (9) CAUTION: Do not reuse old 9. Reassemble the cutter and and is held from rotation by seal parts. Replace all parts volute as outlined in the pin. Unscrew impeller (9) from with new. Mixing old and new replacing grinder parts section shaft in same manner as parts could cause immediate... -
Page 5: Pump Troubleshooting
3. No diametral clearance corrected as outlined above, Pump between radial cutter and contact your nearest factory Troubleshooting cutter ring representative. Start Windings 7.53 If the cause of the trouble Below is a list of troubles and Run Windings 1.56 cannot be determined and their probable causes: No liquid delivered... -
Page 6: Typical Installation
HPGR200 Typical Installation NO PANEL REQUIRED... -
Page 7: Parts List
HPGR200 Parts List 18, 19 Ref. No. Part No. Description Qty. Ref. No. Part No. Description Qty. 14981-001-1 Oil Fill Plug 14885-000-1 Impeller Screw 25338B001 Power Cord 10957-000-2 Volute 14589-002-2 Motor Housing 14569-000-1 Bearing Housing 14570-000-1 Motor 00077-011-1 O-ring 07033-020-3... -
Page 8: Limited Warranty
Your only remedy, and HYDROMATIC’s only duty, is that HYDROMATIC repair or replace defective products (at HYDROMATIC’s choice). You must pay all labor and shipping charges associated with this warranty and must request warranty service through the installing dealer as soon as a problem is discovered. No request for service will be accepted if received after the Warranty Period has expired.
Need help?
Do you have a question about the HPGR200 and is the answer not in the manual?
Questions and answers