Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Hydromatic SK75
Summary of Contents for Hydromatic SK75
- Page 1 Pump Installation and Service Manual SK75/100 Submersible Sewage Ejector Pumps NOTE! To the installer: Please make sure you provide this manual to the owner of the pumping equipment or to the responsible party who maintains the system.
-
Page 2: General Information
If a septic sump condition may Before Operation: working properly. exist and if entry into sump is Read the following instructions 6. A Hydromatic check valve necessary, then (1) provide carefully. Reasonable care and should be installed in the proper safety precautions per safe methods should be practiced. -
Page 3: Pump Installation
Pump Installation 1 HP 3/4 HP CAPACITY-U.S. G.P.M. Duplex SK100 Simplex SK75... -
Page 4: Pump Servicing
Servicing all air bubbles are expelled. before dismantling. Hydromatic pumps have a 2. Check for an obstruction in the small air vent hole in the impeller by looking through Read the following instructions impeller cavity to let out the suction hole of the pump. - Page 5 Attach one meter lead to the stator must be replaced. A zero 9. Unscrew the hex head cap white cord wire and the other reading indicates a direct short, screws (11) and remove the meter lead to the black cord and the stator will have to volute (14).
- Page 6 Repair step 5), Replace the four stator bolts. obtain a new power cord Replace oil plugs (3). assembly from Hydromatic 6. Remove the old O-ring (12), 15.Connect power cord wires to Pump. Refer...
-
Page 7: Parts List
SK75/SK100 Parts List SK75 and 100/1/60 C.I. SK75 and 100/1/60 C.I. Ref. No. Part No. Description Qty. Ref. No. Part No. Description Qty. 4580-001-1 Drive Screw 101-010-1 Cap Screw 13425-069-1 Nameplate 77-003-1 O-Ring 13425-071-1 Nameplate (1Ø w/ plug only) 5677-000-3... - Page 8 All dual seal non-clogs and 3–5 HP grinders must have seal failure and heat sensors attached and functional for Warranty to be in effect. If a seal failure should occur, Hydromatic will cover only the lower seal and labor thereof. Labor is based on Authorized Service Center contract allowance. If the heat sensor is not attached and functional, Warranty is void.
Need help?
Do you have a question about the SK75 and is the answer not in the manual?
Questions and answers