Remote Operations; Running Your Locomotive With The Lionchief Remote - Lionel LionChief Plus Owner's Manual

Remote operations

Running your locomotive set with the LionChief remote
1
Slide the TRANSFORMER/REMOTE switch to the REMOTE position.
Refer to Figure 1 on page 5 for the location of this switch.
2
With track power turned off, place your locomotive on the track.
Power up the track to 18 volts (AC or DC) and move the remote
3
power switch to ON. When the locomotive is powered up, it will beep until it
syncs with the remote. When the locomotive is synced up with the remote, the
locomotive start-up sounds will begin to play.
Note!
4
Move 'em out! Use your remote to run your train. You can adjust the speed in
forward or reverse, blow the whistle, sound the bell, or trigger an announce-
ment. Refer to page 7 for complete details.
5
Turn off the power supply when you are done running your trains.
Switch off your remote control to conserve the batteries.
When in remote mode and powered up on the track, the loco-
motive will continue to beep until it is synced up with its
remote. If the locomotive beeps during operation, be sure that
fresh batteries are installed properly in the remote and the
TRANSFORMER/REMOTE switch is in the REMOTE position.
8