Related Manuals for Lionel Lion Master
Summary of Contents for Lionel Lion Master
- Page 1 73-8045-250 5/03 4-6-4 J3A Hudson Steam Locomotive and Tender Owner’s Manual featuring SYSTEM...
- Page 2 • Flickering firebox and tender • Directional lighting • Odyssey System for speed control with ON/OFF switch The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel ® , TrainMaster ®...
-
Page 3: Table Of Contents
Table of contents Transformer operations Running your locomotive with a Lionel transformer Locking your locomotive into a single operational state Using your tender-mounted ElectroCoupler in the non-Command environment Installing a Lionel Sound Activation Button RailSounds operations Your locomotive’s RailSounds sound system—the basics The RailSounds sound system in the Command environment Experiencing the range of your locomotive’s RailSounds system... -
Page 4: Transformer Operations Running Your Locomotive With A Lionel Transformer
TrainMaster Command Control system, available at your authorized Lionel dealer. Move ‘em out! Get your locomotive moving. Press the DIRECTION button on your Lionel transformer. This sequences the Command reverse unit to the next operating state. Adjust track voltage until your locomotive moves at your desired speed. To increase speed, increase track voltage. -
Page 5: Locking Your Locomotive Into A Single Operational State
Locking your locomotive into a single operational state o select a single operational state for the location of the switch. The locomotive is your Lionel locomotive (for example, now “locked” into your chosen direction. forward only), you can deactivate the When you no longer want single-direction Command reverse unit’s sequencing... -
Page 6: Using Your Tender-Mounted Electrocoupler In The Non-Command Environment
ElectroCoupler. The magnetic coupler on the rolling stock will then react to the Magnetic coupler on the rolling stock coupled magnetic field generated by a Lionel to your locomotive Remote-Control Track section (available separately, 6-65530 for O gauge; 6-65149 or 6-12746 for O-27 gauge;... -
Page 7: Installing A Lionel Sound Activation Button
Lionel no. 610-5906-001 whistle Sound Activation Button for activating the bell The no. 610-5906-001 button works with any Lionel AC transformer except Note! no. 6-4690 Type MW. Transformers made by other manufacturers may not be compatible with RailSounds. -
Page 8: Railsounds Operations Your Locomotive's Railsounds Sound System-The Basics
RailSounds operations Your locomotive’s RailSounds sound system—the basics he Lionel RailSounds sound system is tender body, securing it with the body screws. the most realistic model railroad sound When you first apply track power, the system in the world. Your locomotive locomotive’s RailSounds sound system will... - Page 9 RailSounds operations RailSounds in the Command environment (continued) RailSounds switch Volume control knob REAR FRONT Body screws Body screws Bottom of tender Battery holder Battery harness REAR Speaker FRONT Inside of the tender Figure 4. Servicing the tender...
-
Page 10: Experiencing The Range Of Your Locomotive's Railsounds System
RailSounds operations Experiencing the range of your locomotive’s RailSounds system ith the RailSounds sound system, you seconds, and listen for the air-release experience the sounds of real sound—that’s the locomotive telling railroading like never before. Simply put, you its Command reverse unit has just it’s the most sophisticated, authentic model reset to forward operation. -
Page 11: Odyssey System Operations The Odyssey System
Odyssey System operations The Odyssey System he Odyssey System is a “cruise control” you have on your layout. This digitally- for your locomotive. Once the speed is controlled system also allows for extremely set (see below), your locomotive will slow movement that will amaze any “scale” maintain a constant speed, no matter what enthusiast. -
Page 12: Odyssey System Command Operation
Odyssey System operations Odyssey System Command operation se your CAB-1 to turn the Odyssey power up the locomotive. You may System speed control on or off. The override the default with the following classification lights will flash twice after commands. The override settings will be each sequence has been entered. -
Page 13: Trainmaster Command Operations The Command Control Environment
Lionel-compatible O-31 or larger track. • Make sure track power is OFF before placing on the track. • Make sure your Lionel Command Base is plugged-in and its communications wire is connected to the COMMON post on your Lionel transformer or the U terminal on any of your installed PowerMasters. -
Page 14: Running Your Locomotive In The Trainmaster Command Environment
TrainMaster Command operations Running your locomotive in the TrainMaster Command environment our Command-equipped Example Address Locomotive #1 locomotive comes factory- Set PowerMaster to CMD or traditional programmed with an ID# of “1.” To power supplies to full throttle (no more get your locomotive in action, set than 19 volts) PowerMasters to CMD or set all power... -
Page 15: Cab-1 Numeric Keypad Commands For Your Locomotive
TrainMaster Command operations CAB-1 numeric keypad commands for your locomotive hen you press AUX1 on your CAB-1 Remote Controller, you turn the numeric keypad into ten command buttons. The keypad “stays open” and gives you access to extra command features START-UP until you press any top-row button (SW, ACC, RTE, TR, or ENG). -
Page 16: Tuning Your Locomotive's Performance
TrainMaster Command operations Tuning your locomotive’s performance MOMENTUM For quick remote-control of volume below TrainMaster Command’s momentum the master setting—like muting—use the feature simulates the labored performance CAB-1 numeric keypad’s volume control. of a locomotive pulling a heavy load. Press Press AUX1, 4 on the keypad to lower overall RailSounds output. -
Page 17: Assigning Your Locomotive A New Id
TrainMaster Command operations Assigning your locomotive a new ID# s your fleet of Command-equipped Assign a new ID# to your Example Lionel locomotives grows, you’ll want Command-equipped locomotive to give your locomotive a more individualized number. Choose from any Set the Command reverse unit switch to PROG between 1 and 99. -
Page 18: Reprogramming The Command Reverse Unit To Restore Features
TrainMaster Command operations Reprogramming the Command reverse unit to restore features ue to the inevitable derailments and STEP 5: Press ENG, the ID#, AUX1, then static, it is possible that your Command press 74 for this particular locomotive. reverse unit could someday lose its setup program. -
Page 19: Maintaining And Servicing Your Locomotive
The smoke generator requires the periodic AUX1, 8 on your CAB-1 to turn off the addition of Lionel smoke fluid in order to smoke unit; press AUX1, 9 to turn on the function. A small tube of smoke fluid was smoke unit. -
Page 20: Lubricating Your Locomotive
Maintaining and servicing your locomotive Lubricating your locomotive elp your Lionel locomotive lead a long You’ll know your locomotive requires and productive life on your railroad by lubrication when visual inspection reveals maintaining it properly. dryness on the parts indicated in Figure 5. -
Page 21: Servicing Your Locomotive's Lamps
Lionel Service Center, the cab and the expired lamps. Due to the if it is ever required. complexity of the required disassembly, we recommend that you take your locomotive to your authorized Lionel Service Center for any lamp replacement. -
Page 22: Replacing Your Tender's Lamp
Lionel part no. 610-8049-300, available lamp requires replacement. from your authorized Lionel dealer or from To replace the lamp, remove the body Lionel Service. See Lionel Service section on screws from the underside of the tender and page 24 for more for more information. -
Page 23: Tire-Traction
Slip off the old traction tire can pull many cars at once. and remove it from under the drive rod. Lionel has provided extra traction tires to Place the new traction tire on the wheel and replace the installed traction tires if they... -
Page 24: Limited Warranty/Lionel Service
Center, together with proof of original purchase above instructions carefully before returning any will, at the option of Lionel L.L.C., be repaired or merchandise for service. You may choose to have replaced, without charge for parts or labor. In the...
Need help?
Do you have a question about the Lion Master and is the answer not in the manual?
Questions and answers