Uploading Firmware Via Tftp; Figure 8-3 Stop Auto-Booting; Figure 8-4 Firmware Upload Via Tftp Example - ZyXEL Communications Prestige 861 User Manual

Prestige 861 VDSL Modem
8.4

Uploading Firmware via TFTP

Do not interrupt the file transfer process as this may PERMANENTLY DAMAGE
Step 1. Connect the LAN port to transfer files between the computer and the Prestige and use the console
port to issue the commands.
Step 2. Run a TFTP server program on the computer and configure it to communicate with the Prestige.
Step 3. Specify the server IP address. The server and the Prestige should be on the same subnet.
Step 4. Put the firmware files in the specified directory. Turn on the Prestige and press any key to stop
auto-booting at the prompt "Press any key to stop auto-booting ..... ".
Bootloader Version: V1.6 | 2003/09/09 22:59:45
RAM: Size = 16384 Kbytes
TEST SDRAM: Verifying 832Kbytes
Press any key to stop auto-booting......
Type "help" to get a list of commands
P861>
Step 5. Type "bootp" and press [ENTER]. The message "Bootp Packet received" displays to indicate
the successful packet sending.
Step 6. Follow the instructions in bold type shown in the following figure to finish the upgrade procedure.
bootp
P861>
Our Ethernet address is 00A0 C512 3406.
Sending bootp packet...
....................
Bootp packet received.
Host
Host
Client (target) Ethernet : 00A0 C512 3456
Client (target) IP
tftp zloader loader
P861>
TFTP Start...
Host
Client (target) IP
Loading Filename
Save Address
...
8-4
WARNING!
YOUR Prestige.

Figure 8-3 Stop auto-booting

(server) Ethernet : 0090 CC1A 0B40
(server) IP : 192.168.1.100
: 192.168.1.1
(server) IP : 192.168.1.100
: 192.168.1.1
: zloader
: 0x00010000

Figure 8-4 Firmware Upload via TFTP Example

[OK]
Firmware Upload