Table of Contents
Advertisement
8.1
Firmware Upload Overview
Find firmware at
www.zyxel.com
commands. After a successful upload, the system will reboot.
Only use firmware for your Prestige's specific model. Refer to the label on the
8.2
Checking System Firmware Version
Syntax:
version
This command displays the current system firmware version. An example is shown next.
P861:/> version
VDSL/DMT P861 version V1.1(BV.0)B6 (October 28 2003)
P861:/>
8.3
Uploading Firmware via FTP
Do not turn off the device while writing flash is in progress!!
Step 1. Make sure you are in the same directory where you put the firmware file, and then enter "ftp
192.168.1.1" in the command prompt line as shown next.
Step 2. Type any character in the User (192.168.1.1: (none)): field and press [ENTER].
Step 3. Enter "1234" or what you have set in serial or telnet management interface in the Password field
and press [ENTER].
Step 4. Now you are ready to upload new firmware file to the Prestige by issuing the following ftp
commands:
Firmware Upload
This chapter tells you how to upload new firmware.
and refer to the following sections for upgrading firmware using FTP
bottom of your Prestige.
Figure 8-1 Version Command Example
Prestige 861 VDSL Modem
Chapter 8
Firmware Upload
8-1
- Quick Links:
- What Is Dsl
- Front Panel
- Appendix A Troubleshooting
Hide quick links:
Advertisement
Table of Contents
