Set Pvc Channel - ZyXEL Communications Prestige 861 User Manual

Prestige 861 VDSL Modem

5.9.5 Set PVC Channel

If you change a PVC parameter(s), you need to disable that PVC and then
Syntax:
pvc set <n> <mode> <vpi> <vci> <class> <parameters>
This command sets the encapsulation mode and some parameters of the PVC you specify.
OPTIONS
<n>
<mode>
<vpi>
<vci>
<class>
<parameters>
<pcr><cdvt>
5-10
vdsl> pvc set 0 enable
Erase Block at : 0x205f0000.
vdsl>
Figure 5-5 PVC Set Command Example 1
This is the PVC you specify by entering "0".
Select the e
Encapsulation for Bridged Protocols) or vcmuxbridged(VC Based
Multiplexing of Bridged Protocols).
Enter the Virtual Path Identifier from 0 to 255.
Enter the Virtual Channel Identifier from 32 to 65535.
Type cbr (Continuous Bit Rate) to specify fixed (always-on)
bandwidth for voice or data traffic. Type ubr (Unspecified Bit Rate)
for applications that are non-time sensitive, such as e-mail. Type
vbrnr (Variable Bit Rate non Real Time) or vbrrt (Variable Bit Rate
Real Time) for bursty traffic and bandwidth sharing with other
applications.
Enter the parameters according to the ATM QoS type.
This command is for ubr or cbr class.
Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find
the Peak Cell Rate (PCR). This is the maximum rate at which the
sender can send cells. The valid range for the PCR is from 360 to
262144.
The valid range for the CDVT(Cell Delay Variation Tolerance) is from
1 to 100.
reactivate it.
DESCRIPTION
ncapsulation
mode which can be llcbridged(LLC
VDSL Commands