Electrical Connection - Miele G 7825 Operating Instructions Manual

 All electrical work must be carried out by a suitably qualified
and competent person in accordance with local and national safety
regulations.
– In the U.K. it must comply with BS 7671.
– We recommend connecting the machine to the power supply via a
suitable IP 44 plug and socket which must be easily accessible for
servicing and maintenance work after the machine has been in-
stalled. An electrical safety test must be carried out after installation
and after any service work.
– For hard-wired machines, connection should be made via a suitable
mains switch with all-pole isolation which when in the off position
ensures a 3 mm gap between all open contacts.
– Equipotential bonding should be carried out if required.
– For technical data see data plate or wiring diagram supplied.
– For increased safety, it is recommended to protect the machine
with a suitable residual current device (RDC) with a trip current of
30 mA.
– Check that the phase rotation is correct when connecting the ma-
chine. Failure to do so could have an adverse effect on the circula-
tion pump and impair the wash quality.
Further notes on electrical connection are given on the Installation
diagram supplied with the machine.
The machine must only be operated with the voltage, frequency and
fusing shown on the data plate.
The data plate showing relevant test marks is located on the cover
behind the service panel on the unclean side of the machine.
The wiring diagram is supplied with the machine.
WARNING
THIS APPLIANCE MUST BE EARTHED

Electrical connection

59