Loading The Machine - Miele G 7825 Operating Instructions Manual

Areas of application
Loading the ma-
chine
20
 Only items which have been declared by their manufacturer as
suitable for machine reprocessing may be processed. The manu-
facturer's specific reprocessing instructions must be observed.
Disposable instruments must not be put into the machine for pro-
cessing.
– Arrange the load so that water can access all surfaces. This en-
sures that it gets properly cleaned.
– Do not place items to be cleaned inside other pieces where they
may be concealed.
– Hollow instruments must be thoroughly cleaned, internally and ex-
ternally.
– Ensure that instruments with long narrow hollow sections can be
flushed through properly before placing them in inserts or connect-
ing them to jets.
– Hollow vessels should be inverted and placed in the correct mobile
units, modules and inserts to ensure that water can flow in and out
of them unrestricted.
– Deep-sided items should be placed at an angle to make sure water
runs off them freely.
– Tall, narrow, hollow items should be placed in the centre of the bas-
ket if possible to ensure better water coverage.
– Take apart any items which can be dismantled according to the
manufacturer's instructions and process the individual parts separ-
ately from each other.
– Lightweight items should be secured with a cover net (e.g. an A 6)
and small items placed in a mesh tray to prevent them blocking the
spray arms or being attracted by the magnetic strip on the auto-
matic mobile unit recognition system.
– Only reprocess small items and micro components in special in-
serts, mesh trays with lids or mesh inserts, such as e.g. E 473/1 for
micro components.
– The spray arms must not be blocked by items which are too tall or
which hang down in their path. If in doubt, test for free movement
by manually rotating the spray arms.
– It is advisable to use only instruments made of special application
steel which are not susceptible to corrosion.
– Items made of nickel and colour-anodised aluminium require spe-
cial processing conditions as they are not normally suitable for ma-
chine reprocessing.
– Heat-sensitive items must only be reprocessed using a chemo-
thermal programme.
– Plastic items must be thermally stable.