Miele G 7825 Operating Instructions Manual page 13

Washer-disinfector
Table of Contents

Advertisement

Take care when handling chemical agents. These may contain irrit-
ant, corrosive or toxic ingredients.
Please observe the chemical agent manufacturer's safety instructions
and safety data sheets.
Wear protective gloves and goggles.
The machine is designed for operation with water and recommen-
ded additive chemical agents only. Organic solvents and flammable
liquid agents must not be used in it.
This could cause an explosion, damage rubber or plastic components
in the machine and cause liquids to leak out of it.
The water in the cabinet must not be used as drinking water.
Be careful when sorting items with sharp pointed ends and posi-
tioning them in the machine that you do not hurt yourself or create a
danger for others.
When using this machine in the higher temperature ranges, be es-
pecially careful not to scald or burn yourself or come into contact with
irritant substances when opening the door. Where disinfecting agents
are used there is a danger of inhaling toxic fumes.
Where there is a risk of toxic or chemical substances occurring in
the suds solution (e.g. aldehyde in the disinfecting agent), it is essen-
tial to regularly check door seals and make sure that the steam con-
denser is functioning correctly. Opening the machine door during a
programme interruption carries particular risks in such circumstances.
Should personnel accidentally come into contact with toxic va-
pours or chemical agents, follow the emergency instructions given in
the manufacturer's safety data sheets.
Mobile units, modules, inserts and the load must be allowed to
cool down before they are unloaded. Any water remaining in contain-
ers could still be very hot. Empty them into the wash cabinet before
taking them out.
After using the hot air drying unit, open the door to allow the
everything in the cabinet from the load itself to the mobile units, mod-
ules and inserts to cool down.
If "Boiler ready" has been programmed for the boiler heating, re-
member that hot water or steam may escape when the door is open.
The inlet pipe is below the left-hand basket guide rail, as seen from
the unclean (infeed) side.
Do not touch the heating elements if you open the door directly
after the end of a programme. They remain hot even for some time
after the programme has ended and can cause burns.
Steam heating is permissible up to a pressure of 1000 kPa (10 bar).
This corresponds to a water steam temperature of 179°C.
Warning and Safety instructions
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

G 7826

Table of Contents