Table of Contents
Advertisement
Chapter 6: Basic operation introduction
When system starts, it will automatically detect and identify the number and
location of input cards and output cards. The LCD panel will display the
information accordingly. The introduction of basic operations is based on full
configuration (4 PCS of input cards and 2 PCS of output cards) and the default
menu will be as follows when system starts:
6-1 Select input signals for input cards
Press "SDI, DVI, VGA or Video" to select a signal and press "In-A, In-B,
In-C or In-D" to select an input card for operation.
6-2 PIP setup of input cards
Press "PIP" and then select "SDI, DVI, VGA or Video" as the signal for
PIP. Press "In-A, In-B, In-C or In-D" to select an input card for
operation.
6-3 Text overlay setup of input cards
Press "Text" and select "SDI, DVI, VGA or Video" as the signal for Text
overlay. Press "In-A, In-B, In-C or In-D" to select an input card for
operation.
6-4 Setup of the correspondence between output channels and input
channels for output cards
When the indicator for "Matrix" is on and that for "Overlap" is off, press
"CH1, CH2, CH3 or CH4" to select the output channel and press"In1,
In2, In3 or In4" to select the input channel. Press "Out-K" or "Out-L" to
select an output card for operation.
In-A(Input Card A)
Source：
DVI
Status：
No PIP/Text
Out-K(Output Card K)
Out Channel：
CH4->CH3->CH2->CH1
Ch Source：
In4 In3In2 In1
In Card：
In-AIn-BIn-CIn-D
Display Mode： M1
Config Mode： 6
Out1=CH1+CH2+CH3+CH4
Figure 6-1
LVP8601 User Manual
0s
www.videowall.cn
20
Advertisement
Table of Contents
