Table of Contents
Advertisement
Init2
dial
pin
paponly
backup_wait
pipe
wakeup [on/off]
vid
pid
status
E
x
a
m
p
l
E
x
a
m
p
> wan modem pin 0000
> wan modem status
Modem Link Speed=0
Current Signal Strength=0
Last Fail Message:
Current Connect Stage:
T
e
l
n
e
t
C
o
m
m
T
e
l
n
e
t
C
o
m
m
This command allows you to Ping a specified IP to detect the WAN connection (static IP or
PPPoE mode).
S
y
n
t
a
x
S
y
n
t
a
x
wan detect [wan1][on/off/always_on]
wan detect [wan1]target [ip addr]
wan detect [wan1]ttl [1-255]
wan detect status
S
y
n
t
a
x
S
y
n
t
a
x
Parameter
on
off
always_on
target
ip addr
664
Set the second initial modem AT command.
Set dial modem AT command (default value is "ATDT*99#").
Set PIN code for SIM card.
"0":disable
It means PAP Only. Set the PPP authentication of the USB WAN.
on: None.
off: PAP or CHAP.
Set waiting time after boot if USB WAN is in backup mode. This
waiting time is reserved for the dial of main WANs so that the
backup USB WAN will not go up first.
Available setting is from 1 to 255. Unit is second.
It is for RD debug only. Please don't use it without our advice.
It is for RD debug only. Please don't use it without our advice.
Set VID of VID/PID match to bind the USB modem to specify WAN
interface. By default, this match is not set (0x0/0x0) and the router
specifies WAN interface by USB port.
Set PID of VID/PID match to bind the USB modem to specify WAN
interface. By default, this match is not set (0x0/0x0) and the router
specifies WAN interface by USB port.
Display current status of USB modem.
e
l
e
a
n
d
:
w
a
n
d
e
t
e
c
t
a
n
d
:
w
a
n
d
e
t
e
c
t
D
e
s
c
r
i
p
t
i
o
n
D
e
s
c
r
i
p
t
i
o
n
Description
It means to enable ping detection. The IP address of the target shall
be set.
It means to enable ARP detection (default).
disable link detect, always connected(only support static IP)
It means to set the ping target.
It means the IP address used for detection. Type an IP address in this
field.
Vigor3220 Series User's Guide
Advertisement
Table of Contents
