Table of Contents
Advertisement
Periodic Inform Settings
STUN Settings
Apply Settings to APs
After finishing all the settings here, please click OK to save the configuration.
348
Auto Configuration Server.
Port – Sometimes, port conflict might be occurred. To solve
such problem, you might change port number for CPE.
Username and Password – Type the username and password
that VigorACS can use to access into such CPE.
The default setting is Enable. Please set interval time or
schedule time for the router to send notification to CPE. Or
click Disable to close the mechanism of notification.
The default is Disable. If you click Enable, please type the
relational settings listed below:
Server IP – Type the IP address of the STUN server.
Server Port – Type the port number of the STUN server.
Minimum Keep Alive Period – If STUN is enabled, the CPE
must send binding request to the server for the purpose of
maintaining the binding in the Gateway. Please type a
number as the minimum period. The default setting is "60
seconds".
Maximum Keep Alive Period – If STUN is enabled, the CPE
must send binding request to the server for the purpose of
maintaining the binding in the Gateway. Please type a
number as the maximum period. A value of "-1" indicates
that no maximum period is specified.
This feature is able to apply TR-069 settings (including STUN
and ACS server settings) to all of APs managed by Vigor2925
at the same time.
Disable – Related settings will not be applied to VigorAP.
Enable – Above settings will be applied to VigorAP after
clicking OK to save the configuration. If such feature is
enabled, you have to type the password for accessing
VigorAP.
AP Password – Type the password of the VigorAP that
you want to apply Vigor2925's TR-069 settings.
Vigor3220 Series User's Guide
Advertisement
Table of Contents
