Table of Contents
Advertisement
DHCP Server
Configuration
When you finish the configuration, please click OK to save and exit this page.
104
Subnet Mask - Type in an address code that determines the
size of the network. (Default: 255.255.255.0/ 24)
RIP Protocol Control,
Disable - deactivate the RIP protocol. It will lead to a
stoppage of the exchange of routing information between
routers. (Default)
Enable – activate the RIP protocol.
DHCP stands for Dynamic Host Configuration Protocol. The
router by factory default acts a DHCP server for your network
so it automatically dispatch related IP settings to any local
user configured as a DHCP client. It is highly recommended
that you leave the router enabled as a DHCP server if you do
not have a DHCP server for your network.
If you want to use another DHCP server in the network other
than the Vigor Router's, you can let Relay Agent help you to
redirect the DHCP request to the specified location.
Start IP Address - Enter a value of the IP address pool for the
DHCP server to start with when issuing IP addresses. If the
1st IP address of your router is 192.168.1.1, the starting IP
address must be 192.168.1.2 or greater, but smaller than
192.168.1.254.
IP Pool Counts - Enter the maximum number of PCs that you
want the DHCP server to assign IP addresses to. The default is
50 and the maximum is 253.
Lease Time - Enter the time to determine how long the IP
address assigned by DHCP server can be used.
Use LAN Port – Specify an IP for IP Route Subnet. If it is
enabled, DHCP server will assign IP address automatically for
the clients coming from P1. Please check the box of P1.
Use MAC Address - Check such box to specify MAC address.
MAC Address: Enter the MAC Address of the host one by one
and click Add to create a list of hosts which can be assigned,
deleted or edited from above pool. Set a list of MAC Address
nd
for 2
DHCP server will help router to assign the correct IP
address of the correct subnet to the correct host. So those
nd
hosts in 2
subnet won't get an IP address belonging to 1
subnet.
Add – Type the MAC address in the boxes and click this button
to add.
Delete – Click it to delete the selected MAC address.
Edit – Click it to edit the selected MAC address.
Cancel – Click it to cancel the job of adding, deleting and
editing.
Vigor3220 Series User's Guide
st
Advertisement
Table of Contents
