Table of Contents
Advertisement
Packet-OVERDRIVE
Burst
Tx Power
WMM Capable
APSD Capable
After finishing all the settings here, please click OK to save the configuration.
200
128 bit sync field. However, some original 11b wireless
network devices only support long preamble. Click Enable to
use Long Preamble if needed to communicate with this kind
of devices.
TM
TX
This feature can enhance the performance in data
transmission about 40%* more (by checking Tx Burst). It is
active only when both sides of Access Point and Station (in
wireless client) invoke this function at the same time. That
is, the wireless client must support this feature and invoke
the function, too.
Note: Vigor N61 wireless adapter supports this function.
Therefore, you can use and install it into your PC for
matching with Packet-OVERDRIVE (refer to the following
picture of Vigor N61 wireless utility window, choose Enable
for TxBURST on the tab of Option).
Info
Set the power percentage for transmission signal of access
point. The greater the value is, the higher intensity of the
signal will be.
To apply WMM parameters for wireless data transmission,
please click the Enable radio button.
The default setting is Disable.
* means the real transmission rate depends on
the environment of the network.
Vigor3220 Series User's Guide
Advertisement
Table of Contents
