Table of Contents
Advertisement
User Profile
Synchronize Internal
RADIUS user list to Local
802.1X user list
After finished the above settings, click OK button to save the settings.
I
I
-
4
-
4
-
3
E
I
I
-
4
-
4
-
3
E
It means Terminal Access Controller Access-Control System Plus. It works like RADIUS does.
Click the TACACS+ Setup to open the following page:
Available settings are explained as follows:
138
that is used to authenticate the messages sent between
them. Both sides must be configured to use the same shared
secret. The maximum length of the shared secret you can set
is 36 characters.
IP Address – Type the IP addres of the wired/wireless
client.
IP Mask – Type the subnet mask required for the IP address.
IPv6 Address – Type the IPv6 address of the wired/wireless
client.
IPv6 Length - Type the prefix length required for the IPv6
address.
During the process of security authentication, user account
and user password will be required for identity
authentication. Before configuring such page, create at least
one user profile in User Management>>User Profile first.
Select All – Click it to select all of the user profiles in
Available List.
Clear All- Click to remove all of the user profiles in Available
List.
Available List – The user profiles without RADIUS server
enabled in User Management >> User Profile will be listed
in this field.
Authentication List –The user profiles with RADIUS server
enabled in User Management >> User Profile will be listed
in this field.
Users can be authenticated by RADIUS server and local
802.1X to get certain network service. It is not necessary to
create new user profiles (containing user accounts and user
passwords) for RADIUS and local 802.1X respectively.
Simply check this box; all of the user profiles (prepared for
RADIUS server authentication) listed in Authentication List
will be synchronized for local 802.1X user authentication.
x
t
e
r
n
a
l
T
A
C
A
C
S
+
x
t
e
r
n
a
l
T
A
C
A
C
S
+
Vigor3220 Series User's Guide
Advertisement
Table of Contents
