Cradlepoint IBR1100 User Manual page 69

User Manual / IBR1100/IBR1150
it is offered to higher priority queues first. Move the slider to select from the following options (Default:
Normal):
• Lowest
• Lower
• Below Normal
• Normal
• Above Normal
• High
• Higher
• Highest
Click Finish to save this queue.
Rules
A traffic shaping rule identifies a specific message flow and assigns that flow to one of the queues created
above.
Click Add to create a new Traffic Shaping rule.
Traffic Shaping / QoS Rule Editor
The first page of the Traffic Shaping / QoS Rule Editor allows you enable/disable the rule, name the rule, specify
a protocol for the rule, and select a queue to associate the rule with.
Rule Enabled: (Default: Enabled.) Deselect this to disable this rule. This
can be useful for quickly changing configurations. If both upload QoS
and download QoS are disabled then the rule will disable automatically.
Rule Name: Create a name for the rule that is meaningful to you.
Protocol: The protocol used by the messages: TCP/UDP, TCP, UDP, or ICMP.
Select "Any" if your rule does not control a specific type of message that
uses a specific protocol.
Queue Name: Select a queue to associate this rule with.
Click Next to continue to the next page.
Use ports and/or IP addresses to define the type(s) of traffic attached to this rule. Leaving any field blank will
match all values; all fields are optional.
Source Port(s) and/or Destination Port(s): Enter
a port number between 1 and 65535. To enter
a single port number, input the number into
the left box. To enter a range of ports, fill in
both boxes separated by the colon. For example
"80:90" would represent all ports between 80
and 90 including 80 and 90 themselves.
Source IP Address, Source Netmask,
Destination IP Address, and Destination
Netmask: Specify an IP address or range of IP
addresses by combining an IP address with a
netmask for either "source" or "destination"
(or both). Source vs. destination is defined by
traffic flow. Leave these blank to include all IP
addresses (such as if your rule is defined by a
particular port instead).
©2016 Cradlepoint. All Rights Reserved. | +1.855.813.3385 | cradlepoint.com
7/15/16
69