Cradlepoint IBR1100 User Manual page 56

User Manual / IBR1100/IBR1150
Authentication
More authentication options and overrides are available in the next section.
• Username – Username for user-specific authorization. Leave blank to disable.
• Password – Shared secret (or password) used to authenticate the associated Local and Remote names.
Redial
• Enabled – When this is selected, the tunnel will attempt to reconnect if disconnected.
Add/Edit Tunnel – Authentication
• Remote Name – Authorization name specified
by and to the remote system as its identity,
sometimes a username or hostname. Leave
blank to match any.
• Local Name – Authorization name specified by
and to the remote system as the local system
identity; sometimes a username or hostname.
Leave blank to match any.
Secret – Shared secret (or password) used to
•
authenticate the associated Local and Remote
names.
Overrides
Override Authentication methods/parameters.
With methods set to Allow the two ends of
the tunnel can negotiate a common scheme.
Sometimes this negotiation fails, or the
implementation on one end is incompatible with
the other. To solve those authentication issues,
enable the overrides as needed.
• Authentication – Username for user-specific authorization. Leave blank to disable.
• CHAP – Choose from Allowed, Refused, or Required.
• PAP – Choose from Allowed, Refused, or Required.
• Name – Override names used to authenticate the router. Leave empty to use the default.
Add/Edit Tunnel – Routes
Typically specific routes are unnecessary, but they can be added in this section if needed. You can add or
remove routes to be used to funnel packets through the tunnel.
• Network Address – This is the network address that is the destination of the route. This should be set to
the network address at the remote side of the tunnel.
• Netmask – This is the corresponding subnet mask of the network being defined.
©2016 Cradlepoint. All Rights Reserved. | +1.855.813.3385 | cradlepoint.com
7/15/16
56