Search Options; Edit Custom - Uniden UBCD436-PT Owner's Manual

P25 Threshold Mode – The default setting is Auto.
Auto. Automatically sets the decode threshold based on the received signal.
Manual. Allows you to manually set the threshold in threshold setting mode or using the
P25 Threshold Level setting.
Default. Sets the scanner to the default threshold of 8, Auto.
P25 Threshold Level – The default setting is 8.
5 to 13
Press Menu. Scroll to Search for... and press E/yes.
Scroll to the options below and press E/yes.
IMPORTANT! There are many options and setting in Search/Close Call Options that affect
and compliment the settings for searching. Please review those first.

EdIT CUSTOM

You can edit the 10 Custom Search ranges. The default custom search range names appear as
Custom 1, Custom 2, and so on.
Custom 0-9. Select for each Custom Search.
Edit Name. See Data Naming, page 25.
Edit Srch Limit
Set Lower Limit. Enter the lower limit.
Set Upper Limit. Enter the upper limit.
Set Delay Time
-10, -5, 0, 1, 2, 3, 4, 5, 10, or 30 sec.
Set Modulation
Auto, AM, NFM, FM, WFM, or FMB (Broadcast)
Set Attenuator
On or Off
Set Step
Auto, 5, 6.25, 7.5, 8.33, 10, 12.5, 15, 20, 25, 50, or 100 kHz
Set Audio AGC
Analog - Press E/yes to toggle On or Off.
Digital - Press E/yes to toggle On or Off.
P25 Waiting Time. This setting gives the scanner time to determine if the frequencies
have digital or analog transmissions. During this time, the scanner will evaluate the
received signal and, if it detects digital data, will open squelch immediately. If digital is not
detected before the delay expires, the scanner will open squench at the end of this delay.
This is to prevent "false decode" problems. The default setting is 400 ms.
64

SEARCH OPTIONS

Custom Search Set Search Key
Edit Custom Search with Scan