Uniden UBCD436-PT Owner's Manual page 52

Set Latitude
Enter the latitude. Press ./no to toggle N or S, and press E/yes.
Set Longitude
Enter the longitude. Press ./no to toggle E or W, and press E/yes.
Set Range See also Understanding Range, page 24.
0-6000
Rectangles
New Rectangle
Latitude - Top Left
Enter the latitude. Press ./no to toggle N or S, and press E/yes.
Longitude - Top Left
Enter the longitude. Press ./no to toggle E or W, and press E/yes.
Latitude - Bottom Right
Enter the latitude. Press ./no to toggle N or S, and press E/yes.
Longitude - Bottom Right
Enter the longitude. Press ./no to toggle E or W, and press E/yes.
Stored Rectangle
Edit Rectangle See Rectangles, page 42.
Delete Rectangle
At Confirm Delete? press E/yes or ./no.
P25 Waiting Time (Motorola Only) – This setting gives the scanner time to determine if channels
on mixed Motorola Systems have digital or analog transmissions. During this time, the scanner will
evaluate the received signal and, if it detects digital data, will open squelch immediately. If digital
is not detected before the delay expires, the scanner will open squelch at the end of this delay.
This is to prevent "false decode" problems. This setting only affects channels with an Audio Type
set to All. The default setting is 400 ms.
0 to 1000
Note: Any analog transmissions will lose the first part of the transmission, up to the wait
time you set here.
P25 Threshold Mode (P25/Motorola)
The default setting is Auto.
Auto. Automatically sets the decode threshold based on the received signal.
Manual. Allows you to manually set the threshold in threshold setting mode by using the P25
Threshold Level setting.
Default. Sets the scanner to the default threshold of 8, Auto.
P25 Threshold Level (P25/Motorola) – The default setting is 8.
5 to 13
Delete Site – Deletes the Site.
At Confirm Delete? press E/yes or ./no.
New Site – See New Site, page 39.
42