Table of Contents
Advertisement
Default is Custom 1.
Scroll to the Service Type and press E/yes.
Set Delay Time – This sets (in seconds) the amount of time the scanner stays on a channel
after the transmission has ended before moving to the next channel. A negative delay will force a
resume after that number of seconds.
The default setting is 2 seconds.
-10, -5, 0, 1, 2, 3, 4, 5, 10, or 30 sec.
Set Priority – This sets the channel as a priority channel while scanning. The default setting is
Off.
Note: To use Priority ID Scan you must also enable Priority ID Scan for each System. See
also Priority Scanning, page 49.
On or Off
Set Alert – This setting controls when and how the scanner alerts you if the channel becomes
active. The default setting is Off.
Set Alert Tone
Alert 1-9 or Off.
Set Level
Level 1-15 or Auto (the master volume level).
Set Alert Light
Set Color
Off, Blue, Red, Magenta, Green, Cyan, Yellow, or White.
Set Pattern
On, Slow Blink, or Fast Blink.
Set Avoid – This determines whether a channel will be scanned or not. Temporary Avoids cancel
you cycle power. The default setting is Stop Avoiding.
Stop Avoiding, Temporary Avoid, or Permanent Avoid
See also Scanning, page 50.
Volume Offset – This sets the Volume Offset for the Channel. See Scanning, page 50.
-3, -2, -1, 0, 1, 2, or 3
Delete Channel – Deletes the Channel.
At Confirm Delete? press E/yes or ./no.
New Channel – See New Channel, page 45.
Manage Quick Key Status – This is one way to enable or disable your System quick keys and
Favorites Lists quick keys. The other way is using the number keys on the keypad. See Selecting
Quick Keys, page 52.
Favorites Quick Key
Scroll to each Favorites List quick key and press E/yes to enable or disable.
System Quick Key
Scroll to each Favorites List and press E/yes.
Favorites List
SET SCAN SELECTION
47
Hide quick links:
Advertisement
Table of Contents
