Uniden UBCD436-PT Owner's Manual page 51

If you don't have Excel you can download and install a viewer here, or do a simple Google
search.
The upper base frequency can also be found using the Band Plan Calculator located at:
http://info.uniden.com/twiki/bin/view/UnidenMan4/CalculatingUpperBaseFrequencies.
Also, look at Determining Base/Step/Offset for VHF/UHF Motorola Systems at Radio
Reference.com.
For Standard 800 MHz Rebanded Systems, you need to set Band Plan 1 and Band Plan 2
as follows:
Band Plan Lower Base Freq
1 851 .025
2 851 .0125
Select Plan 1-6 Select for each Band Plan.
Set Base Freq
Input Lower. Enter the lower base frequency and press E/yes.
Input Upper. Enter the upper base frequency and press E/yes.
Set Offset
Input Offset. Enter the offset and press E/yes.
Select Polarity. Scroll to + (default) or - and press E/yes.
Set Spacing. Scroll to the step size and press E/yes.
Press Menu to return and repeat for each band plan as needed.
Set Frequencies – This is where you program trunking frequencies for the Site.
New Frequency/Edit Frequency. Enter the frequency and press E/yes.
For EDACS and LTR sites only:
Input LCN. Enter the LCN number and press E/yes.
Delete Frequency
At Confirm Delete?, press E/yes or ./no.
Set Modulation (no P25/P25 One Freq) – This setting selects the modulation used for the Site.
The default setting is Auto.
Auto, NFM, or FM
See also Scanning, page 50.
Set Attenuator – This setting controls whether the scanner attenuates signals on the Site by
about 20 dB The default setting is Off.
On or Off
See also Scanning, page 50.
Set Avoid – This determines whether a Site will be scanned or not. Temporary Avoids cancel
when you cycle power. The default setting is Stop Avoiding.
Stop Avoiding, Temporary Avoid, or Permanent Avoid
See also Scanning, page 50.
Set Location Information – This allows you program a location for the Site to use with Location
Control enabled or with a GPS. You can program a circle with a radial range or multiple rectangles
as a location.
See Set Up GPS (page 24) first to set your location format and the Baud rate.
Circle
Upper Base Freq Offset
854 .000 440
868 .9875
Polarity Spacing
+ 25 khz
0 + 25 khz
41