Lamp Change - Projectiondesign F22 User Manual

V

LAMP CHANGE

The LAMP indicators on the keypad will turn red when lamp life
expires.
Change the lamp when lifetime expires. Always replace lamp with
the same type and rating.
The lamp includes an electronic lamp timer that is tracking the life
time of the lamp.
Always disconnect the power cord and wait until the projector
has cooled down (60 minutes) before opening the lamp cover .
A Release the screw (LAMP 1) or (LAMP 2) depending on which lamp
that needs to be replaced.
B Open the lamp lid(s).
C Turn the three locking screws a quarter turn anti-clockwise.
D Pull the lamp out.
Replace with a new lamp in reverse order.
E Insert a new lamp. Observe the guide pins.
F Turn the tree locking screws a quarter turn clockwise.
H Close the lamp lid.
I Turn the locking screw clockwise.
WARNING
Be careful not to touch the protective glass when replacing the
lamp house, this may cause the protective glass to overheat and
break while in use.
WARNING
Be extremely careful when removing the lamp module. In the
unlikely event that the bulb ruptures, small glass fragments may
be generated. The lamp module is designed to contain these
fragments, but use caution when removing the lamp module.
Downloaded from ProjectorsManual.com Manuals
A
I
B
H
C
F
D
E
31