Set Up - Projectiondesign F22 User Manual

K

SET UP

SET UP VIDEO
Before setting-up, switch off all equipment.
Four video sources may be connected, using the
YPbPr (component), BNC (RGB), S-VIDEO (super
video) and VIDEO (composite video) inputs.
Component and RGB video will display more detailed
images. Composite video yields images with less
detail.
In addition, the DVI-D input can be used with video
sources (DVD player fitted with an HDCP TM compliant
DVI or HDMI connector) for a pure digital connection.
Connect the power cord.
SETUP COMPUTER
Before setting-up, switch off all equipment.
The projector may be connected to up to three
computer sources simultaneously, using the VGA,
BNC and DVI inputs.
The VGA and BNC interfaces are analog and may
cause some noise in the projected image, depending
on the signal quality from the graphics card in the
computer.
The DVI (Digital Visual Interface) interface is all-digital
and will yield a projected image with very low noise.
Connect the RS232 interface to allow for individual or
global control of multiple units in a daisy chain
configuration.
Connect the LAN connector for individual control and
monitoring of multiple projectors over LAN.
Connect the power cord.
Downloaded from ProjectorsManual.com Manuals
15