Remote Control - Projectiondesign F22 User Manual

I

REMOTE CONTROL

The remote control allows flexible access to the
projector settings, either through direct keys, or
through the menu system. The remote control is
backlit for use in dark environments. It also has a data-
jack that allows for wired connection to the projector.
When the wire is connected, the IR (infra-red) beam
and internal batteries are switched off.
The remote control can be operated either in
'broadcast mode', or 'individual mode'. When several
projectors are in use in an installation, individual control
may be convenient. Individual control is available either
by wired remote control, using the data-jack, or by
using an individual number code.
For individual control, first set the individual RC ID code
using the projector menu system, see the UTILITIES
sub menu.
Then, to select a specific projector to control, first
press the ' ' button in the lower keypad area, then the
*
code as set in the target projector. A code can be in
the range '0'..'255'. '0' is reserved for broadcast. To
select another target, repeat the process by pressing
' ' and a new code. To exit individual control, press
*
' '' ' twice or press ' ' and '0'.
* * *
POWER
Switches the projector between on and standby
modes.
AUTO
Adjusting the projector to display a correct image,
including position, width, height, contrast, brightness
and overall stability.
INFO
Displays source and projector status on screen.
BACKLIGHT
Switches the backlight on and off. The backlight will
switch off automatically after ten seconds.
C-VIDEO
Selects the composite video input as signal source.
S-VIDEO
Selects the super video input as signal source.
YPbPr
Selects component video input.
DVI
Selects the DVI input.
VGA
Selects the VGA input.
BNC
Selects the BNC input.
Downloaded from ProjectorsManual.com Manuals
12