M
LAMP OPERATION
The projector is fitted with two individual projection lamps that can be
run in various modes. In addition, lamps can be replaced as needed
separately. This ensures an optimized cost of ownership. Individual
lamp timers are maintained for each lamp.
Lamp operation mode is controlled in the LAMPS sub menu.
Downloaded from ProjectorsManual.com Manuals
N
PIN CODE
The projector may be controlled by a PIN (Personal Identity Number)
code. The PIN code is 4 digits, and if the PIN code is activated, you
must issue the right code to unlock the projector.
To activate the PIN code, see the UTILITIES sub menu.
If a wrong PIN code is issued, you may try again two times. If you fail
three times in a row, a PUK (unnlock) code is needed. The PUK code
is supplied with the product.
If you also fail three times with the PUK code, the projector locks up
permanently, and can only be unlocked by a special service unlock
code.
To access this code, you will need to contact your dealer or a service
station. The service unlock code will be generated based on a secure,
encrypted number that is produced by the projector itself. The
projector will produce a new number every time.
17