Using The Projector - Projectiondesign F22 User Manual

P

USING THE PROJECTOR

After setting-up, switch on all equipment.
The projector can be controlled by the keypad on the rear, by the
remote control or using the RS232 or LAN interfaces.
When using the remote control, either all or select individual units may
be addressed, see the CONTROL sub menu - RC ID. By activating the
RC ID, individual control of units in a multiple-unit set-up is then made
possible.
To switch the projector on, firmly press the POWER button on the
keypad or the remote control. The STATUS indicator will turn from
yellow to green when the unit is switched on. The keypad will light up
so that all available functions are yellow. Functions not available will
have no light. Selected functions will turn green.
If the STATUS indicator is flashing yellow, please wait until it turns
permanent yellow.
When only one source is connected, the projector will auto-detect that
source. If more sources are connected, the projector will search for the
next active source according to the following list, provided that
SOURCE SCAN is set to ON in the SET UP sub menu (see description
of menu system):
- VGA
- BNC
- DVI-D
- YPbPr (Component)
- S-Video
- C-Video
Select between the sources by pressing the SOURCE buttons on the
keypad or the remote control. Only sources that are active will be
displayed.
If no source is active, searching messages will appear on the screen.
If no source is active for a long time, the projector will go in standby
mode if DPMS (power save) is set to ON in the SET UP sub menu. The
STATUS indicator will turn from green to flashing yellow, then yellow.
The projector will be switched back on if at least one source is
(re)activated. The power-down function can be disabled in the menu.
See DPMS in the SET UP sub menu.
To switch the projector off, firmly press the POWER button on the
keypad or the remote control twice (to confirm that you really want to
switch off the unit). The STATUS indicator will turn from green to
flashing yellow, then yellow when switched off.
You may not switch the unit on while the STATUS indicator is flashing
yellow. Please wait until the indicator is permanent yellow.
Downloaded from ProjectorsManual.com Manuals
CONTROL SUB MENU
mode
RS232 Address auto
RS232 Fixed
baudrate
RC ID
SET UP SUB MENU
keystone V 0
keystone H 0
IR control
DPMS
source scan
orientation
OSD
language
RGB Video
RS232
fixed
1
19200
0
press
on off
on off
desktop front
off
20