Cleaning The Filter In The Water Inlet - Miele G 7881 Installation And Operating Instructions Manual

Cleaning the filter in the water
inlet
There are filters in the screw connection
of the water inlet hose to protect the
water inlet valve. When the filters
become dirty, they need to be cleaned
so that enough water can flow into the
wash cabinet.
,
The plastic housing of the water
connection contains an electrical
component. It must NOT be
submerged in water.
Correcting faults
Cleaning the filter
^ Disconnect from the power supply.
^ Turn off the water supply and
unscrew the water inlet hose.
^ Clean the large area filter (1) and fine
filter (2) and replace with new filters if
needed.
^ Put the filter and seal back into place
and make sure they are sitting
correctly.
^ Reconnect the water inlet valve to the
water valve, making sure it goes on
straight.
^ Slightly open the water tap.
If there is a leak, check that the
connection is on straight and tight
enough.
^ Straighten it to sit correctly, then
tighten and test again.
65