Buzzer - Miele G 7881 Installation And Operating Instructions Manual

Programmable functions

Buzzer

The buzzer can be programmed for the following functions:
– Program end = Constant buzzer,
– Fault warning = Buzzer at 1-second intervals, and
– Sample-collection signal = sets of 3 short beeps followed by a 2-sec pause.
Contact Miele Customer Service to program the sample-collection signal.
The numbers shown in the display correspond to the following settings:
20 Buzzer off
21 End of program (factory setting)
22
Error
23
End of program + Error
24 Sample-collection signal
25
End of program + Sample-collection signal
26
Error + Sample-collection signal
27 End of program + Error + Sample-collection signal.
Step
^ Activate the programming mode as per page 35.
^ Press the "Drying" 0 button until E04 appears in the
display.
^ Turn the program selector to the "Wash" program.
^ Press or hold down the "Display" ß button until the
required value appears in the display, e.g., 26.
^ Save to memory and exit programming mode as per
page 35.
Value selected:
The buzzer will sound for 30 sec at the value selected.
To switch it off earlier:
– Turn the program selector to the 12 o'clock position f .
– Press the "Display" ß button.
– Interrupt the power supply, e.g., open the door.
44
Display / Result
E04
21
26