Servicing; Operational Warnings - VTL TL6.5 Owner's Manual

Ensure that the TL6.5 is installed in a location that is stable and well ventilated. If the
preamplifier is placed in a built-in installation, ensure that there is adequate room for air to
flow through the ventilation openings. Allow at least 3 - 5 inches clearance on the top and
around the sides of each chassis of the preamplifier. The warranty does not cover units
that are damaged due to overheating from incorrect installation.
It is also recommended that the preamplifier be sited at least 10 inches away from the
power amplifier to prevent possible noise introduction into the system.
Tiptoes or other isolation accessories may prove useful in reducing mechanical vibrations
or other external vibrations that might affect sonic performance, and we have found that
such accessories can offer definite beneficial sonic improvements when used correctly. In
all cases this preamplifier should only be installed in a location that is stable, as warranty
does not cover damage due to the unit falling.
Do not place the preamplifier next to heat sources such as radiators, stoves or other
appliances.
Do not place the preamplifier where small children might be able to tamper with the
equipment. If it is not possible to place the preamplifier out of the reach of small children
it is recommended that power cables be removed when the equipment is not in use.

Servicing

Do not attempt to service the TL 6.5 beyond the procedures
described in this manual. For all other service and questions, please
contact your authorized VTL dealer or the factory.

Operational Warnings

TL6.5 Preamplifier Owner's Manual
VTL
It is critical for proper sonic performance of this
component that it be properly configured for the mode
of operation while playing. If a balanced signal is
applied to the inputs the unit must be configured for
balanced operation, and vice-versa.
Always make all connections before powering the TL 6.5 on.
Connecting or disconnecting the TL 6.5 while powered on
can damage the output stage, and will not be covered under
the warranty. Ensure that no interconnect cables can become
loose during use and that there are no intermittent faults or
shorts with the cables.
Do not attempt to disassemble the TL 6.5 chassis or
remove any covers from the unit. Always consult with your
VTL authorized dealer or the VTL factory before attempting
4