Led Indications - VTL TL6.5 Owner's Manual

View Input Level Offset: (In Lock Out
Mode only)
Suppress Out-of-Balance display
Re-enable the Out-of-Balance display
Disable Input: Disabled inputs cannot be
selected and used in any way after being
disabled.
Re-enable Input: To re-enable the input.
Programming Lock Out Mode: Setting and
resetting of Triggers, Unity Gain, Balanced or
Single-ended mode for any input, and input
Offset are all disabled.
Restore Programming Mode: Remove the
Lock out mode to enable Trigger, Unity
Gain, Balanced/Single-ended selection, and
Input Offset.

LED Indications

Power LED:
When the unit is powered on by pressing the Power button on the front panel, the LED
light will be lit. When the unit is powered off, the LED lights are turned off.
Blink blue during Power up sequence and the trigger sequence.
Remain steady blue after power up and trigger sequence.
Inputs 1 & 2 LED (CD1, CD2)
During Power up sequence, these LEDs will blink RED if that trigger (either inputs 1
and 2) is programmed, else no LED is lit.
During trigger sequence, blink red until trigger activates, then steady red while other
triggers activate, then off after all programmed triggers activated.
TL6.5 Preamplifier Owner's Manual
VTL
00.
Hold the Input button and the numeric display will
button will indicate the Offset value.
Hold the Balance button and press the Mute
button.
Hold the Balance button and press the Mute
button again.
While the preamp is in Power-on mode, select the
input you wish to disable and hold down the Mute
button at the same time.
While the preamp is in Power-on mode, select the
input you wish to re-enable and hold down the
Mute button at the same time.
This setting is done during Power down cycle only.
Hold the Mon/Proc button and press the Power
button on the front panel and release the
MON/Proc button after pressing the Power
button.
This setting is done during Power up cycle only.
Hold the Mon/Proc button and press the Power
button on the front panel, and release the
MON/Proc button after pressing the Power
button.
24