Operating Modes And Factory Default Settings - VTL TL6.5 Owner's Manual

and Tape In connectors, respectively, as per the instructions in the Getting Started section of this
manual. While the tape deck is in recording mode, set the preamplifier to monitor mode by
pressing either Tape 1 or Tape 2 while holding the Mon/Proc button.. This allows the
preamplifier to play back the recording simultaneously while the tape is recording the selected
source. In this mode the volume of the Tape monitor input is regulated by the main volume
control on the TL 6.5.
Caution: Before engaging the Tape monitor switch be sure to turn the volume
control all the way down to 00.

Operating Modes and Factory Default Settings

Powering the TL 6.5 off from the front panel or remote wand will save all of the
existing settings to memory for use at a later power up. Loss of power before the
settings are saved will cause the settings to be lost from memory, and the preamplifier
will have to be programmed again and the settings saved by powering down from the
front panel or remote power buttons. Powering down from the rear rocker switch has
the same effect as loss of power, and does not save settings to memory.
Function
Suppress timer countdown
Trigger output
Inputs CD1, CD2, Ph/Aux1
(Defaults to input CD1 selected)
Volume setting
Mute
Input level offsets
Phase
Channel Balance
Unity Gain input
Tape Monitor
Suppress Out of Balance display
Programming Lock Out
TL6.5 Preamplifier Owner's Manual
VTL
Default Mode
Not set
None set
Balanced mode
Zero volume
Not selected
Not set
Phase correct
Not selected, no imbalance
Not set
Not set
Not set
Not set
22
Indication
Timer decrements
None
Selected input LED
color is blue
00 on numeric display
Mute LED off
None
Phase LED off
Bal LED off
None
Mon/Proc LED off
None
None