Tl 6.5 Front Panel Controls - VTL TL6.5 Owner's Manual

Locate the red Power button on the front panel of the unit located on the far left side of the
Preamplifier. Push the power button to turn on the Preamplifier. You will see the blue Power
on LED above the red Power button start to blink and the Numeric Display now displays the
99 to 0 warm-up countdown sequence.
Step 6. Turn on your Source component
Step 7. Turn on your Power Amplifier(s)
Step 8. Wait for the TL6.5 to finish warmup
After the TL 6.5's warm-up countdown is completed, the Power on LED turns to a steady blue
indicating that the unit is now ready to play. Please note that the Numeric Display now
indicates 00 volume. CD1 is the selected source and the LED above CD1 is blue to indicate
that the default selection of CD1 is in balanced mode. If your Source component is setup in
balanced mode, you are now ready to play your music. Turn the volume to the appropriate level
by rotating the Volume/Control knob.
If your Source component is used in single-ended mode, change the CD1 input to single-ended
by holding down the CD1 button steady until the LED changes to green. Start playing your
music and turn the volume to the appropriate level by rotating the Volume/Control knob.
Congratulations! You have just completed the Quick Start section of your TL-6.5
Preamplifier manual. Now please read the rest of this manual while relaxing and
listening to your favorite music.

TL 6.5 Front Panel Controls

From the front panel of the unit you can access all of the controls and program all the
functions of the preamplifier, as well as from the rear-mounted RS-232 port
Fig. 1 Front Panel
TL6.5 Preamplifier Owner's Manual 8
VTL