Adjusting Audio Recording Level - JVC GY-HM600E Instructions Manual

Adjusting Audio Recording Level

You can select to adjust the audio recording levels
for the two channels (CH1/CH2) manually or
automatically.
CH1 CH2
INT
INPUT1
INPUT2
LC
AUTO
MANUAL
CH1 CH2
Manual Adjustment Mode (Manual
Adjustment)
Set the [CH1/CH2 AUTO/MANUAL] switch on
0
the camera recorder to "MANUAL" to enter the
manual adjustment mode, and use the [CH1]/
[CH2] recording level adjustment knob to set the
recording level.
You can adjust the level manually during the
0
recording, recording standby, and stop modes.
o Setting Input Channel to "INPUT1"/"INPUT2"
1 Set the [CH1/CH2 AUTO/MANUAL]
selection switch to "MANUAL" for the
channel to be adjusted manually.
2 Turn the corresponding [CH1]/[CH2]
recording level adjustment knob to adjust
the level.
When [Audio Set] B [Limiter] is set to "Off",
adjust such that the audio level meter does not
light up at -2 dB even for loud sounds.
(A P106 [ Limiter ] )
4030 20 10 0
P 13000K
4030 20 10
FULL AUTO
ON
OFF
00: 00: 00.00
Jan 24,2012
12 :34 :56
5 . 6f t
ND 1 /64
AE 6
+
0
dB
F1.6
1/ 100
0
-2dB
o Setting Input Channel to "INT" for Both [CH1] and
[CH2]
1 Set the [CH1 AUTO/MANUAL] selection
switch to "MANUAL".
2 Turn the [CH1] recording level adjustment
knob to adjust the level.
When the built-in microphone and the [AUX]
input terminal are used, the recording levels of
[CH1] and [CH2] are interlocked.
This is also effective when the [CH1 AUTO/
MANUAL] selection switch is set to [CH2].
Memo :
Select [Limiter], [AGC Response], [AGC Mode],
0
or [Int. Mic Separation] in the menu to set the
recording audio.
For the reference level to be recorded to an SD
0
card, set [Main Menu] B [A/V Set] B [Audio
Set] B [Ref. Level] to "-20dB", "-18dB", or
"-12dB". (common for CH1/CH2)
(A P106 [ Ref. Level ] )
The operations of the [CH2] recording level
0
adjustment knob and [CH2 AUTO/MANUAL]
selection switch are disabled.
Automatic Adjustment Mode
Set the [CH1/CH2 AUTO/MANUAL] selection
0
switch to "AUTO" or the [FULL AUTO] switch to
"ON" to enter Automatic Adjustment mode. The
audio recording level is set automatically
according to the input level.
When the [FULL AUTO] switch is set to "ON",
0
mode switching with the [CH1/CH2 AUTO/
MANUAL] selection switch is disabled.
Memo :
When [Main Menu] B [A/V Set] B [Audio Set]
0
B [Limiter] is set to "Off" while in the automatic
adjustment mode, the limiter operates at
-5 dBFS.
If [Limiter] is set to other than "Off", the limiter
operates according to the value set.
(A P106 [ Limiter ] )
When [A/V Set] B [Audio Set] B [Audio On FULL
0
AUTO] is set to "SW Set", you can switch the
audio recording mode with the [CH1/CH2
AUTO/MANUAL] selection switch on the
camera recorder even if the [FULL AUTO]
switch is set to "ON".
(A P107 [ Audio On FULL AUTO ] )
61